Descargar Imprimir esta página

dormakaba LA GARD 700 Serie Guia Del Usuario página 57

Ocultar thumbs Ver también para LA GARD 700 Serie:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 159
Important: To update the Lock and Keypad Firmware to the newest version, the Manager user will require the
following:
A PC with the 700 Series LA GARD Software
A 700 Series USB Dongle (Part # 7047040)
A USB-to-Mini-USB Cable (Part # 203325)
The version of firmware currently on your device can be viewed using a Keypad with a display, or by using a PC
and the LA GARD software. For keypads with a display, navigate through the menus to find the current
application FW levels of both the Keypad and any locks. For a PC with LA GARD software, the current versions
of all four files can be determined when doing a 'Compare' operation from the PC-Link dialog. You will find this
information on the 'Additional Info' tab.
Follow these steps to update the Firmware from the LA GARD software client to the Keypad:
Important: when updating FW on a system mounted to a safe, always ensure the safe door is open prior to the
beginning of the FW update process.
1.
Connect the Keypad to the PC by doing the following:
a. Plug the 700 Series USB Dongle into the USB Port of the PC
b. Plug the USB-connector end of the cable into the dongle
c. Plug the mini-USB end of the cable into the mini-USB port on the Keypad
2.
On the Keypad, enter a valid User ID and the corresponding combination.
3.
From the LA GARD Software Main Menu, select Settings.
4.
Fill out the following information in the software's Firmware Update sub-menu:
Port – From the drop-down menu, select the applicable comms port
Firmware File – Use the Select File button to navigate through the computer to find the
firmware update file. Select Open in the browser window when the file is located
If lock firmware is selected, another option will be presented to select which lock to update
5.
If using a Keypad with a display, do the following:
Using the Arrow buttons on the Keypad, navigate through the Main Menu and select System by
pressing the <return key> (←).
In the System menu, navigate through the options and select FW Update by pressing the <return
key> (←). Start FW Update will appear on the display screen.
If using a Keypad without a display do the following:
use the #99 command with an Authorized user combo to set the Keypad into the FW Update
Mode by using the following keystrokes at the keypad:
#99<Master or Manager PIN><return key>
o
Note: Locks must be installed before updating Firmware
6.
In the software client, select the Upload button. A progress bar will appear on screen. The Keypad will beep
three times and flash a green LED once complete. If for some reason the FW update process has been
interrupted, restart the process again from the SW.
dormakaba USA Inc. System User Guide 7040.1121 Rev E2 10/22 | 55

Publicidad

loading

Este manual también es adecuado para:

La gard 701La gard 702La gard 703La gard 704La gard 705