1 Introduction
This guide outlines general information for using and programming LA GARD 700 Series Models 701-
705 electric combination safe locks and all its components, including accessories and software client.
This guide assumes the installer has knowledge of electrical, mechanical, and computer concepts, as
well as having familiarity with safe lock systems and associated components. For reliable and safe
operation of the equipment, comply with all safety precautions outlined in this guide.
1.1 Approved Standards
The LA GARD family of safe locks conform to the following approved standards:
•
UL 2058 (High Security Electronic Locks)
•
EN 1300:2018
•
Model: 705 – FCC ID: 2ASNP-705, IC ID: 24793-705
•
Model: DKLG70X – FCC ID: 2ASNP-DKLG70X, IC ID: 24793-DKLG70X
•
VDS 2395 Class 2, Models: 701-704
•
SBSC 3880:2015, Models: 701-704
•
CNPP A2p – Level B/E, Models: 701-704
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by dormakaba USA Inc. could void the user's authority to
operate the equipment.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:
1.
This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
dormakaba USA Inc. System User Guide 7040.1121 Rev E2 10/22 | 6