RIDGID 122 Manual Del Operador página 10

122 Copper Cutting and Prep Machine
Figure 8 – Reaming I.D. of Tube
Cleaning Inside of Fittings
1. Check that brush is the correct size for the fitting
diameter. Install correct size fitting brush if necessary.
2. Turn ON/OFF switch to ON position.
3. Push fitting over fitting brush (Figure 9). Hold fitting
securely to prevent rotation.
Keep fingers away from brush.
CAUTION
4. Turn ON/OFF switch to OFF position.
Figure 9 – Cleaning Inside of Fittings
Deburring O.D. of Tube
NOTE! Outside deburring disk is an accessory and
sold separately.
1. Turn ON/OFF switch to ON position.
2. Remove external burrs by placing on rest plate.
Lengths of tubing longer than six feet should be sup-
ported by pipe stands.
8
All manuals and user guides at all-guidesbox.com
3. Rotate tube against deburring cutter (Figure 10).
This action also bevels the end of the tube for easier
insertion into fitting.
4. Turn ON/OFF switch to OFF position.
Figure 10 – Deburring O.D. Of Tube
Accessories
Only the following RIDGID products have been designed
to function with the No. 122 Cutting and Prep Machine.
Other accessories designed for use with other tools may
become hazardous when used on this machine. To pre-
vent serious injury, use only the accessories listed below.
Accessories For No 122 Cutting and
Prep Machine
Cat. No.
46105
33551
10343
36662
Ridge Tool Company
WARNING
Description
Outside Debur Disk
Stainless Steel Cutter Wheel (Requires Special
10343 Wheel Pin)
Cutter Wheel Pin for 33551 Cutter Wheel
Model 301A Foot Switch – 120V