Publicidad
Idiomas disponibles
Idiomas disponibles
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
3. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting process.
If not used for long periods of time, remove battery to
prevent damage to transmitter. Store the remote away
from excessive heat or humidly. (Figure 3)
4. If you have multiple fans and want to program all
fans to one handheld control. Slide the Dip Switch with
the same position in ALL receiver to ONE handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process. Each fan needs
to be no more than 30 feet from the handheld control
that you would like to program. Please note the wall
switch that controls the power to your fan(s) should be
in the off position until you are ready to program your
handheld remote(s).
5. If you have multiple fans and want to program each
fan to separate handheld controls. Slide the Dip Switch
with the same position in both receiver and handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process below. Repeat
these steps for each fan that you would like to program
to a separate handheld remote. Please note that the wall
switch that controls the power to your fan(s) should be
in the off position until you are ready to program your
handheld remote(s).
How to Operate Your Ceiling Fan
WARNING
WARNING
For illustrative purposes only-not
intended to cover all types of controls
3V CR2032
Battery (2 pcs)
14
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3
Publicidad
