Fanimation LEVON MAD7912B Serie Manual página 7

1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 6 (Figure 1).
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4 (Figure 2).
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black/white, blue, red, gray and yellow wires
and safety cable through the downrod.
4. Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 4)
WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.
How to Assemble Your Ceiling Fan
(Figure 3)
Downrod
Set Screw
Hairpin
Clip
Downrod
Set Screw
w/Hex Nut
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black/White, Blue, Red,
Gray, Yellow wires and
Safety Cable
Set Screws
and nuts (2)
Figure 3
Hairpin
Clip
Figure 4