Parkside PFBS 160 C3 Manual Del Usuario página 13

■ Always remove batteries from appliances that
are not in use, if possible.
■ Do attempt to recharge non-rechargeable
batteries.
There is a risk of explosion!
Original accessories/auxiliary
equipment
■ Use only the accessories and auxiliary equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Operation
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place.
♦ Undo the tensioning nut
using the combination spanner
♦ Remove any attached tool.
♦ First push the intended tool through the
tensioning nut before inserting it into the
appropriate collet chuck
shaft.
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination spanner
Using an accessory tool with a mandrel
♦ Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrels or
♦ Insert the respective mandrel
the appliance as described.
♦ Use the combination spanner
screw on the mandrel
♦ Insert the desired accessory tool between the
two washers on the screw.
♦ Use the combination spanner
screw on the mandrel
PFBS 160 C3
and hold it down.
until the lock clicks
from the thread
.
for the tool
and hold it down.
into the thread insert
tight with the
.
.
, or into
to undo the
or .
to tighten the
or .
Whet stone
♦ Do manually grind any edges with the whet
stone .
Fitting abrasive belts
♦ Push the abrasive belt
belt mandrel . Tighten the screw on the abra-
sive belt mandrel
belt .
Fitting polishing attachments
♦ Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■ The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol).
Switching on/setting the speed range
♦ Set the ON/OFF switch
♦ Set the speed control
"1" and "MAX".
Switching off
♦ Move the ON/OFF switch
"O".
Using the grip ring with LED light
♦ Unscrew the union nut
thread.
♦ Screw the grip ring with LED
the screw thread.
♦ Move the ON/OFF switch of the LED light
the position "I" to switch it on (see fig. C).
♦ Move the ON/OFF switch of the LED light
the position "O" to switch it off again.
onto the abrasive
in order to fix the abrasive
onto the tip
(anti-
to the "I" position.
to a position between
to the position
anticlockwise off the
clockwise onto
GB │ IE │
.
to
to
9 ■