Assembly Of The Sprocket On The Head - JF 1000 AT Manual De Instrucciones

A
B
FIX THE SPROCKET
I N T H E B O T T O M
HOLE
E
C
ASSEMBLY OF THE SPROCKET ON THE
HEAD
1.
Put the sprocket (A) on the shaft (B).
2.
Fix the sprocket (A) on the shaft with the hex
bolt (D), flat washer (C) and hex nut (E).
NOTE!
The shaft has two holes for securing the sprocket.
Set in the bottom hole
NOTE!
The screws, nuts and washers are located in the
kit supplied with the head.
D
C = flat washer Ø10 mm (01 un)
D = hex bolt M10 x 75 mm (01 un)
E = hex nut M10 with nylon lock (01 un)
JF 1000-AT
29