Publicidad
Idiomas disponibles
Idiomas disponibles
2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water
supplies before beginning.
• Install INLINE FILTER (3) on each wall supply outlet.
Be sure that INLINE FILTER (3) is inserted in the
correct direction. (See Illustration)
• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to
INLINE FILTER (3). Connection on fitting supplies are
3/8" compression. Connect left supply hose (Red
Label) to Hot wall supply. Connect right supply hose
(Blue Label) to Cold wall supply. Use adjustable
wrench to tighten connections. Do not over tighten.
* Faucet supplies are 35" long from faucet base.
• Note: If additional supply length is required,
installer must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
C
3
CONNECT SPRAY HOSE, SOLENOID ASSEMBLY, AND INSTALL WEIGHT
• Push the SPRAY HOSE END (1) into FEMALE ADAPTER (2)
and slide down locking collar to secure connection.
• Orient solenoid valve with the orientation label facing up.
• Push SOLENOID ASSEMBLY (3) connection "B" into the
HOSE CONNECTOR (4) as shown, and slide down
locking collar towards SOLENOID ASSEMBLY (3) to secure
connection.
• Push SOLENOID ASSEMBLY (3) connection "A" into other end
of FEMALE ADAPTER (2) as shown, and slide locking collar
towards SOLENOID ASSEMBLY (3) to secure connection.
• With SPRAY HEAD (5) seated in SPOUT (6), install WEIGHT (7)
onto HOSE (6) 24 inches from the underside
of the sink deck and secure with LATCH (8).
NOTE: there is a label on the hose indicating
weight placement.
• Important: Make sure you pull out hose
and check to see that it moves freely and
is not obstructed by supply hoses,
solenoid valve or items in the bottom of
the cabinet.
(3) INLINE
FILTER
HOT
6
5
B
Slide
Locking
Collar
locking
collar to
secure
A
2
1
3
COLD
IMPORTANT: Do not
use sealent on threads
4
3
2
18"
1
7
8
6
Publicidad
