OHAUS 3000 Serie Instrucciones De Montaje página 147

3000 Series Indicators
2.4 T31P Rear Cover Orientation
The T31P is delivered in the wall mount orientation
with the connections exiting below the display. The
rear housing may be reversed so the connections
exit above the display when the T31P is placed
horizontally on a bench. See Figure 2-4. To reverse
the rear housing, remove the four Phillips head
screws, carefully rotate the housing 180°, and
reinstall the screws.
CAUTION: Take care not to pinch any internal
cables attached inside.
2.5 Direct Wall Mounting (T31P only)
The T31P indicator may be mounted directly to a wall using two screws (not included). Select appropriate size screws that fit
into the holes at the bottom of the indicator housing. See Figure 2-5. When mounting to a wall without a solid backing, use
appropriate anchoring hardware.
2.6 Mounting Bracket (T31XW only)
Attach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type of mounting surface. The
bracket will accommodate up to 6 mm (1/4") diameter screws. Locate the mounting holes as shown in Figure 2-6.
Figure 2-3. Wall Mount Configuration.
Figure 2-5. T31P Direct Wall Mounting.
Figure 2-6. Mounting Bracket Dimensions.
Figure 2-4. Bench Top Configuration.
Wall Mounting Holes
EN-13