Starting Current Limitation - Hilti DCG 180-D Manual Del Usuario

3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a hand-held electric angle grinder. It is designed for cutting and grinding metal and
mineral materials without use of water. It may used only for dry cutting / grinding.
The tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type plate.
3.3 Items supplied
Angle grinder, guard, side handle, clamping flange, clamping nut, wrench and operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
3.4

Starting current limitation

The electronic starting current limiter reduces the starting current drawn by the power tool and thus prevents
the mains fuse blowing. It also allows the angle grinder to start smoothly, without a jolt.
3.5 Active Torque Control (ATC)
The electronics detect potential stalling of the disc and prevent further rotation of the drive spindle by
switching off the tool.
If the ACT system has been triggered, restart the tool. Do this by releasing the on/off switch and then
pressing it again.
If the ATC system malfunctions, the electric tool will run only at greatly reduced speed and with greatly
reduced torque. Have the tool checked by Hilti Service.
3.6 Restart interlock
The angle grinder does not restart by itself when the on/off switch is in the pressed position and the power
returns after an interruption in the electric supply. The on/off switch must first be released and then pressed
again to restart.
71878
*71878*
Printed: 29.03.2018 | Doc-Nr: PUB / 5069492 / 000 / 03
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
¡
Spindle lockbutton
Threaded bushing for the side handle
Side handle
Release lever for pivotable side handle
On/off switch
Wrench
Clamping nut
Kwik lock clamping nut (optional)
Abrasive cutting disc / abrasive grinding disc
Clamping flange with O-ring
Hood
Adjusting screw
Clamping lever
Spindle
Keyed locating lug
Steadying rib
English 21