Transport And Storage; Manufacturer's Warranty - Hilti DCG 180-D Manual Del Usuario

Maintenance
▶ Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
◁ Do not continue to operate the power tool if signs of damage are found or if parts malfunction.
▶ Use only genuine
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
9

Transport and storage

• Do not transport electric tools with accessory tools fitted.
• Always unplug the supply cord before storing an electric tool or appliance.
• Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
• Check electric tools or appliances for damage after long periods of transport or storage.
10 Troubleshooting
If the trouble you are experiencing isn't listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The power tool doesn't start.
The tool does not achieve full
power.
11 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
71878
*71878*
Printed: 29.03.2018 | Doc-Nr: PUB / 5069492 / 000 / 03
accessories for repairs.
Possible cause
Interruption in the electric supply.
The supply cord or plug is defec-
tive.
The carbon brushes are worn.
DCG 180-P
The restart interlock is active after
disconnection or an interruption in
the electric supply.
The extension cord conductor
cross section (gauge) is inade-
quate.
Malfunction in the ATC system.
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Have the supply cord and plug
checked by a trained electrical
specialist and replaced if
necessary.
▶ Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
▶ First release the on/off switch
lockbutton and then switch on
again.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Have the product repaired by
Hilti Service.
English 27