Garland SCAR 322 E Manual De Instrucciones página 23

children, other people and animals coming into the
working area.
Do not use this machine at night, with fog or with
reduced visibility that does not allow you to see the
working area.
2.4. ELECTRICAL SECURITY
The electrical switch of this machine must coincide
with the mains switch. Do not modify the switch in
any way. If no parts have been modified and they fit
perfectly, there will be no electric shock accidents.
Avoid body contact with earthed surfaces such as
tubes, radiators, electric kitchens and refrigerators.
There is a higher electric shock possibility if your
body is earthed.
Don't expose this machine to rain, wet or humid
conditions. If water enters the machine there will be a
higher risk of electrc shock.
Do not overstretch the cable. Do not use the cable
to transport the machine, lift the machine and to
unplug the machine. Maintain the cable far away
from heat sources, oil, sharp edges or other moving
parts. Damaged or tangled cables increase the risk
of electric shock.
Never use this machine if the cable or the plug are
damaged. Before connecting the machine check
that the cable and the plug are not damaged. If you
discover that either of these elements are damaged,
take your machine to your nearest after sales dealer.
Should the cable be damaged, unplug the machine
inmediately. Damaged or tangled cables increase the
risk of electric shock.
The substitution of the plug or cable should be
done by an approved and homologated after sales
service. We recommend that this machine should be
connected to residual differential whose current is
lower or equal to 30mA.
Never use a connecting base that is damaged or
that does not comply with current normatives or
with the requisites established for this machine in
this manual.
When using a cable extension, make sure that its
minimum section is 2,5mm2 and no longer than 25
metres, always unrolled and adequate for outdoor
use. The use of the cable extension adequate for
outdoor use, reduces the risk of electric shock.
Place the cable extension in such a way that it will
not get caught in branches or other obstacles and
in such a way that it is not in the working area. The
cable and any extensions must always be behind the
machine and the end user.
Always hold the cable extension in the hook provided
on the machine.
Connect this machine to alternate current
230v/50Hz.
Do not touch this machine with wet hands. Risk of
electrc shock.
Maintain the cable well clear of the cutting element
at all times.
23/112
English