Garland SCAR 322 E Manual De Instrucciones página 24

English
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Always disconnect the machine before carrying
out any work on the machine. Only manipulate the
machine when disconnected.
2.5. USAGE AND CARE OF THIS MACHINE
Only scarify areas with grass. Do not use this
machine for other uses. For example: do not use
the machine to weed, sweep or to sand any type
of surface. The use of this machine for other uses
for which it has not been designed could cause
dangerous situations.
Use this machine, accessories and all its parts
according to the instruction manual and taking
into account working conditions and working area.
The use of this machine for jobs different to those
specified in the instruction manual can cause
dangerous situations.
The manufacturer will not be in any case held
responsible for damages caused through an
inadequate or incorrect usage of this machine.
Do not overload the machine. Use the machine
for the work it has been designed for. The correct
machine usage will allow you to work better and in a
more secure way.
Do not run with the scarifier. Walk at the correct
speed that will allow the machine to do its job.
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Look after the machine. Check that all moving parts
are well aligned and that they are not blocked, that
there are no broken pieces or other conditions that
could affect the proper functioning of the machine.
If this machine is damaged, always repair it before
using it again. Most accidents occur because of poor
maintenance.
Maintain the cutting elements sharp and clean. The
cutting elements if sharp and clean will cut better, do
a better job, have less chance of getting tangled and
easier to control.
Turn off and disconnect the machine from the mains
before carrying out any maintenance work such as
adjustments, cleaning, transportation (even if you are
just moving the machine from one working area to
another however close by this might be), elevating
the machine, maintenance or storage of the machine.
These simple security measures reduce the risk of
accidental start up.
Do not incline the machine with the engine running.
2.6. MAINTENANCE
Take your machine for periodic revision to a qualified
after sales dealer and only use original spare parts
and accessories. This will guarantee that the security
measures of this electris machine can always be
complied with.
24/112