JOCCA 2168 Manual De Instrucciones página 5

English EN
- The appliance must not be wall or ceiling mounted. It must always
be placed on a dry flat surface in a well ventilated area.
- Please do not use the appliance near a source of heat, such as fire
place, kitchen stove, heating appliance, etc.
- Do not use the appliance with wet hands or barefoot.
- Never touch the moving parts of the appliance. Never put your
fingers or any other object in the air inlet or outlet. Never insert any
object that might block or break the appliance.
- Check that the air outlets on the rear and front of the appliance are
not blocked. Do not cover the air in let or outlet when the appliance
is operating.
- Do not use the appliance in the bath or the shower or in rooms with
a damp atmosphere.
WARNING ABOUT THE BATTERIES
- Remove the battery from its compartment, if you are not going to
use the device for a long period of time.
- Remember that batteries must be deposited in the specialized
containers for battery collection.
- If you want to throw out the device, always remove the batteries
before doing it.
- Replace the battery when it is worn out.
- Only the batteries of the same model or equivalent to the
recommended can be used.
- The battery must be placed in accordance with the indicated correct
polarity.
- Never place the battery compartment near fire or heat source.
- Do not throw the batteries into fire or place the control unit to the
sun.
- Do not mix new batteries or the old and worn-out.
INSTRUCTIONS FOR USE
- ATTENTION: Before proceeding with its assembly or disassembly, make
sure that the appliance is NOT plugged into the mains.
- Remove all parts of the appliance from the packaging and remove all
packaging materials and inserts.
- Put the fan upside down, loosen the fixing ring at the bottom of the body.
- Prepare the base which consists of two halves, before connecting the two
halves, please make sure the power cord goes through the hole on the
base. Then put the base connected. Make sure that the two halves are well
connected, to do so, press the two tabs and bring the two halves together
until they click.
- Pass the power cord at the bottom of the base through the cord exit slot.
Check image 1 and 2.
- Make sure that the power cable 6 is in the intended depression. Check
picture 3.
5