Operating The Unit - Gaggenau DF 260 Instrucciones De Manejo

You can delay the start of the program in 1-hour steps up to 24 hours.
Open the door. Power on the unit.
C
Press + or – button until the displayed time corresponds with your
requirements.
Press START button. Delay start is activated.
You can change your program selection at any time until the program starts.
Close the door
The cycle completion is also indicated by a tone.This function can be changed as
Open the door. Power on the unit.
A
Release both buttons.
A
C
= Off and
Press START to save the setting.
The running time may increase slightly. (Caution if utensils are delicate!)
Open the door. Power on the unit.
A
Release both buttons.
Press START button. The set value is saved.
Close the door.

Operating the Unit

For hidden controls, open the door.
Turn unit on by pressing the ON/OFF switch. The display of the last
Press the START button.
Close the door. The program starts running.
Open the door.
Press the ON/OFF button. The LEDs go out. The program is saved. If the door
was opened on an appliance which has a warm water connection or is heated,
(pressure) may cause the appliance door to spring open or water to run out of
the appliance.
To continue the program, switch on the ON/OFF switch again.
Close the door.
WARNING
To avoid risk of scalding, OPEN THE DOOR CAREFULLY during any wash or
rinse cycle. Do not fully open the door until water noises have stopped.
= loudest
.
15