Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 20 Tuesday, December 20, 2022 10:47 AM
20 INSTALLATION
3
Make sure the hole in the burner head is
positioned over the electrode.
Oval (center) burner head/cap assembly
a
Medium burner head and cap
b
Small burner head and cap
c
Large burner head and cap
d
Front of range
e
Extra large burner head and cap
f
Hole
g
Electrode
h
Checking Ignition of the Surface
Burners
Electric Ignition
Select a surface burner knob and simultaneously
push in and turn to the Lite position. You will hear
a clicking sound indicating proper operation of the
spark module.
Once the air has been purged from the supply
lines the burner should ignite within 4 seconds.
After the burner ignites, rotate the knob out of the
Lite position. Try each burner in succession until
all burners have been checked.
Quality of Flames
The combustion quality of the burner flames
needs to be confirmed visually.
Yellow flames
Call for service.
Yellow tips on outer cones
This is normal for LP gas.
Soft blue flames
This is normal for natural gas.
NOTE
• With LP gas, some yellow tipping on outer cones
is normal.
Adjusting the Surface Burner to the
Low Flame (Simmer) Setting
1
Light all surface burners.
2
Turn the knob on the burner being adjusted
to Lo.
3
Remove the knob
4
Insert a small, flat-blade screwdriver into the
valve shaft.
Valve shaft
a
Center adjustment screw
b
5
Turn the screw to adjust.
• Hold the valve shaft with one hand while
turning the screw to adjust with the other.
Publicidad
