Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 66 Tuesday, December 20, 2022 10:47 AM
66 TROUBLESHOOTING
Problem
Oven will not Self
Oven controls improperly set.
Clean. (On some
• See the Self Clean section.
models)
A Self Clean cycle cannot be started if the oven Control Lock / Lockout feature is active.
• See the "Control Lock / Lockout" in "Changing Oven Settings" section.
Oven door does not
Oven is too hot.
open after a Self
• Allow the oven to cool below locking temperature.
Clean cycle (On some
models)
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
The oven is not clean
Oven controls not properly set.
after a Self Clean
• See the Self Clean section.
cycle (On some
models)
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
CLEAN and door
The Self Clean cycle has been selected, but the door is not closed.
flash in the display
• Close the oven door.
(On some models)
"Loc" is on in the
The oven is locked because of the Control Lock / Lockout feature.
display when you
• Deactivate the Control Lock / Lockout feature.
want to cook (On
some models)
Oven control beeps
Electronic control has detected a fault condition.
and displays any F
• Remove the power from the range for five minutes and then reconnect the power. If the
code error.
• Check the main gas shut-off valve or the oven gas shut-off valve and call for service.
The oven racks were
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
cleaned in a Self
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
Clean cycle. (On
some models)
Displayed colon in
This means that the product has just been plugged in, or that it has experienced a
the clock is flashing
power interruption.
• This is normal. Reset the clock and any cooking function.
Light can be seen
While the Broil function is running, it is normal to see a light between the oven air
through the oven air
vents.
vents.
• This is normal.
Range is not level.
Poor installation.
• Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at
• Be sure floor is level and strong and stable enough to adequately support range.
• If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel.
• Be sure cabinets are square and have sufficient room for range clearance.
door can be opened when the lock
Self Clean again or for a longer period of time.
function error code repeats, call for service.
racks with the paper towel. Do not use lubricant sprays.
base of range until the oven rack is level.
Possible Cause & Solution
k
is no longer displayed.
Publicidad
