Korg D1WH Manual Del Usuario página 17

When using the ST-SV1 optional keyboard
The D1 can be used with an ST-SV1 keyboard stand (the
ST-SV1 BK model, sold separately). For the D1, use the
instructions shown below instead for step 8 when assem-
bling the ST-SV1 BK.
Using two people, lift the D1 (A), and attach it to the ST-
SV1 stand (B).
While one person prevents the D1 from falling down, The
other person lines up the screws (o) on the left and right
of the ST-SV1 with the screw holes (n) on the bottom of the
D1. As a guide, the plate (f) should fit right between the
two grooves (p) on the center of the bottom of the D1. Be
careful that the plate does not touch the screw (k) at center
front of the bottom of the D1 and the head of the screw (l)
in the center towards the back.
Align the holes (n) under the D1 to match the screws (o) of
the ST-SV1.
Remove the included AC adapter before assembling
1
stand (sold separately)
the ST-SV1.
Be very careful not to pinch your fingers during lifting
and attaching the D1 to the ST-SV1.
Make sure that the D1 is firmly secured to the ST-SV1
before playing. Failure to secure the ST-SV1 may cause
the D1 to fall off and injure you, or cause damage to
the D1.
2
17