Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Step 7. Assemble the surface burners
CAUTION
Do not operate the surface burners without all burner parts in place.
Position surface burner heads on top of the surface burner manifolds as
1.
shown in the picture on the right. The electrodes will fit into the slot in the
bottom of the heads. Make sure the surface burner heads are flat and parallel
with the cooktop.
2.
Place the matching size caps on top of each surface burner head.
Top
24 English
DG68-01512A-00_IM_DOP48x960Gx_DA_EN+MES+CFR.indb 24
DG68-01512A-00_IM_DOP48x960Gx_DA_EN+MES+CFR.indb 24
7.
After installing and leveling the range,
carefully remove Air Sled and install
front leg covers (right, center and left).
Bottom
3.
•
•
•
Step 8. Check the ignition of surface burners and oven burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1.
2.
Place the left and right surface burner
grates on the cooktop. The edges of the
grates should match up with the edges
of the cooktop.
NOTE
Grates should be placed on its
own position because they are not
interchangeable.
You can recognize the right position of
the grates by checking the bottom side
of each. Look for engraved position on
right and left grate, RIGHT FRONT and
LEFT FRONT respectively.
The grates are heavy. Be careful while
handling the grates.
Push in the control knob, and then turn
it to the Lite position. You will hear a
'clicking' sound indicating the electronic
ignition system is working properly.
Turn the control knob to adjust the
flame level.
2023-04-07 오후 5:22:39
2023-04-07 오후 5:22:39
Publicidad
