Publicidad
Idiomas disponibles
Idiomas disponibles
Locking screw
Locking screw
DG68-01512A-00_IM_DOP48x960Gx_DA_EN+MES+CFR.indb 27
DG68-01512A-00_IM_DOP48x960Gx_DA_EN+MES+CFR.indb 27
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If flames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
flames are stabilized.
If flames are too yellow and/or too large,
gradually increase the air shutter opening
until the flames have approximately a 1 in
blue cone.
NOTE
If the range is set up for natural gas, the
flames should burn with minimal yellow
tipping. If the range is set up for LP gas,
small yellow tips at the end of the cones are
normal.
After the flames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
To adjust flame low setting
Identify which burner is exhibiting too high or too low simmer flame size, adjust
as necessary by following steps below:
1.
Simmer Set
Screw
Small
2.
Screwdriver
3.
Valve Stem
WARNING
1.
Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve
set screw will cause gas to leak.
2.
After adjusting the valve set screw, inspect the assembly for gas leaks.
Rotate a knob to Lo position and
remove the knob from the valve stem
while the flame is lit.
Carefully push the screw driver into
the stem of the valve, until it hits
the simmer set screw. Make sure the
screwdriver flathead is seated into the
set screw groove.
Rotate valve set screw clockwise to
decrease Lo setting flame output, or
rotate set screw counter clockwise to
increase Lo setting flame output.
English 27
2023-04-07 오후 5:22:40
2023-04-07 오후 5:22:40
Publicidad
