Publicidad
Idiomas disponibles
Idiomas disponibles
3 Units installation
Select in the Remote Control Switch the proper fan Tap option
according installation Static Pressure requirement.
fan Speed
(RCS)
Static Pressure
setting
SP-01
SP-00 (*)
SP-02
RPI-3.0fSN3E low static pressure setting for very short ducts
fan Speed
(RCS)
Static Pressure
setting
SP-01
SP-00
SP-02
(*):
Factory Setting
SP:
Static Pressure
V(1,2,3,4,5): Fan Tap
rCS:
remote Control Switch
3.1.7 Static pressure setting
rPI units have been provided by three Static Pressure levels regulation
depending on the installation requirements.
High Static Pressure, medium Static Pressure (factory setting) and Low
Static Pressure conditions are available.
Static Pressure setting shall be made from the remote Control Switch.
For changing to High and Low Static Pressure level, refer to the explana-
tion below.
field Setting Mode
Check to ensure that the unit is stopped, press the «OK» switch and the
«rESET» switch on the remote control switch simultaneously more than 3
seconds, and the remote control switch is changed to the field setting mode.
When the remote control switch is at the field setting mode, the «SErVICE»
is indicated and the «01» flickers below the «SErVICE» indication.
Optional Setting Mode
At the field setting mode as described in the above item, press the «TEmP
}" switch or the "TEmP ~ " switch and the number flickering below the
"SErVICE" indication is changed (01 <=> 02). Set the flickering number
at "01", press the "OK" switch, and the remote control switch is changed
to the optional setting mode.
Selection of Indoor Unit
a.
At the optional setting mode, the indication on the remote control
switch is changed as shown in the figure below
Hi
Med
Low
v1
v2
v3
v2
v3
v4
v3
v3
v4
Hi
Med
Low
v2
v3
v4
v3
v4
v5
v4
v4
v5
6
PmmL0230A rev.1 - 06/2011
The indication of "01" is turned ON
Ê
The address of the indoor unit which the optional function is to be set,
is indicated at the segments for timer setting time indication, and the
"ADDS" is indicated below.
The refrigerant cycle number of the outdoor unit for which the optional
function is to be set is indicated at the segments for timer setting time
indication and the "rN" is indicated below.
The indication of the setting temperature is turned OFF.
b.
At the condition of the above item (a), press the "TEmP ~"
switch or the "TEmP }" switch of the remote control switch and
the indoor unit for which the optional function is to be set, can
be changed.
N O T E
• The indoor unit can be selected among the indoor units connected
to the remote control switch.
• In case that both the indications of the address and the refrigerant
cycle number is "AA", the settings of all the indoor units is same.
c.
After selecting the indoor unit, press the "OK" switch, the remote
control switch is changed to the optional setting mode.
Changing of Optional functions and Setting Conditions
a.
At the optional setting mode, the indication on the remote control
switch is changed as shown below.
The indications of "ADDS" and "rN" are turned OFF.
Ê
The item number of the optional function is indicated at the segment
for the setting temperature indication.
The setting condition of the optional function item is indicated at the
segments for timer setting time indication.
Publicidad
