Cameo PIXBAR Serie Manual De Usuario página 15

• Note on the main display in the operating modes with external control: As soon as the control
signal is interrupted, the characters in the display start flashing; if the control signal is present
again, the flashing stops.
• Briefly pressing UP when in the main display rotates the display by 180°.
SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to
select the menu item DMX Address and confirm with ENTER. Using the UP and DOWN buttons,
configure the desired DMX start address and press ENTER to confirm (highest value dependent
upon activated DMX mode).
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to
select the menu item DMX Mode and confirm with ENTER. Now select the desired DMX mode
using UP and DOWN and confirm the selection with ENTER. DMX operating modes with DMX delay
channel and group selection (Group 0 - 24) are marked with "D". Tables with the channel assign-
ments can be found in these instructions under DMX CONTROL.
CLPB400IPG2 CLPB600IPG2
15