Cameo PIXBAR Serie Manual De Usuario página 19

STAND-ALONE OPERATION MODE PLAY LOOP (8-step colour sequences 1 - 8)
The 8 available loops are pre-programmed at the factory, but can be customised in the Edit Loop
menu item. The brightness can be set at a higher level. Starting from the main display, press
MENU to enter the main menu. Using UP and DOWN, select the menu item Stand Alone, confirm
with ENTER, then select the submenu item Auto and confirm again with ENTER. Now select the
menu item you want to edit, confirm the selection and make the settings as desired. Confirm each
entry.
TIMER FUNCTION
The timer function allows timed control of the Direct LED, Colour Preset, CCT and HSI stand-alone
modes in such a way that the fade-in time (Fade In) can be set from 0 to 60 minutes, the dwell
time from 1 to 24 hours and the fade-out time from 0 to 60 minutes. After activation of the timer
function, the timer control will be implemented upon the next system start. Starting from the main
display, press MENU to enter the main menu. Select Stand Alone, confirm the selection, then
select Timer and confirm again. Select the setting On under Timer and confirm. For the individual
timer control settings, select Fade In, Dwell Time or Fade Out and confirm. You can now set the
respective value as desired. Confirm all entries. To deactivate the timer function, select the setting
Off under Timer and confirm the entry.
Note: The timer function is suitable for use in master/slave operation via cable and W-DMX .
™
19