Cameo PIXBAR Serie Manual De Usuario página 17

This will take you to the submenu for configuring the submenu items (see table).
STAND-ALONE DIRECT LED MODE
The stand-alone Direct LED mode allows dimmer, strobe, R, G, B and W (CLPB400IPG2) or R, G, B,
W, A and UV (CLPB600IPG2) to be set directly on the unit, similar to a DMX controller. In this way,
an individual scene can be created without an additional DMX controller.
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
Stand Alone, confirm with ENTER, then select Direct LED and confirm again with ENTER. Now
select the menu item you want to edit, confirm the selection, set the desired value and confirm
the entry.
Control signal is forwarded via DMX OUT
Activate DMX control signal forwarding via W-DMX
Deactivate sending of the DMX control signal via
W-DMX
Pairing with ready-to-pair W-DMX devices
Disconnect all W-DMX connections
Set DMX delay for slave units: Off, 0.1s - 2.0s
Do not forward control signal
CLPB400IPG2 CLPB600IPG2
17