Cameo PIXBAR Serie Manual De Usuario página 16

DMX modes with DMX delay channel
The DMX Delay function is a simple way to create a running light effect with a large number of
spotlights that are all the same model and that are all running the same software version. This
is otherwise only achievable with a suitable DMX controller and time-consuming programming.
All the spotlights used (same models, same software version) are set to the same DMX operating
mode with DMX delay channel and controlled via the same DMX start address.
Setting the DMX delay: Select one of the DMX operating modes with DMX delay channel and
confirm the selection (in the example D4 CH Preset). Assign the spotlights to one of up to 24
groups (plus Group 0) according to preference, whereby several spotlights can be assigned to one
group. The group number is also the factor by which the set delay time set in the DMX controller
is multiplied. Confirm each entry by pressing ENTER.
The delay time (delay time of the DMX signal) is set by means of a DMX controller in the separate
DMX delay channel of the corresponding DMX mode (0.0s to 2.0s in 0.1s increments).
Setup example:
STAND-ALONE MENU MASTER / ALONE
In the stand-alone modes Direct LED, Color Preset, CCT, HSI, Auto Program and Play Loop, the
control signal of the corresponding mode can be output to slave units via XLR (DMX OUT) and
W-DMX™:
Stand Alone -> Master/Alone -> Master
If the output of the control signal is not desired, the output can be deactivated:
Stand Alone -> Master/Alone -> Alone
A delay for slave units can be set for the time-delayed output of the control signal of the
stand-alone modes Auto Program and Play Loop.
Starting from the main display, press MENU to enter the main menu. Now select the Stand Alone
menu item, confirm, select Master/Alone and confirm again.
16