How To Use Your Cb - PRESIDENT JOHNSON II Manual Del Usuario

Ocultar thumbs Ver también para JOHNSON II:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING
YOUR SET FOR THE FIRST TIME (without transmitting and
without using the «push-to-talk» switch on the microphone):
a) Connect the microphone
b) Check the antenna connections
c) Turn the set on by turning the volume knob (1) clockwise.
d) Turn the squelch knob (2) to minimum (M position). Adjust the volume to a
comfortable level.
e) Go to Channel 20 using either the «UP» «DN» key on the microphone or the
rotary knob.
5) ADJUSTMENT OF SWR (Standing wave ratio):
WARNING: This must be carried out when you use your CB radio for the first time
(and whenever you re-position your antenna). The adjustment must be
carried out in an obstacle-free area.
* Using an external SWR meter (e.g. SWR 1 or SWR 2):
a) To connect the SWR meter :
- Connect the SWR meter between the CB radio and the antenna as close as
possible to the CB (use a maximum of 40 cm cable, type President CA 2C).
b) To adjust the SWR meter:
- Set the CB to channel 20.
- Put the switch on the SWR meter to position CAL or FWD.
- Press the «push-to-talk» switch on the microphone to transmit.
- Bring the index needle to  by using the calibration key.
- Change the switch to position SWR (reading of the SWR level). The reading on
the V.U. meter should be as near as possible to 1. If this is not the case, re-adjust
your antenna to obtain a reading as close as possible to 1. (An SWR reading
between 1 and 1.8 is acceptable).
- It will be necessary to re-calibrate the SWR meter after each adjustment of the
antenna.
WARNING: In order to avoid any losses and attenuations in cables used for
connection between the radio and its accessories, PRESIDENT recommends
to use a cable with a length inferior to 3m.
Your CB is now ready for use.
B) HOW TO USE YOUR CB:
1) ON/OFF - VOLUME:
a) To turn the set on, turn the knob (1) clockwise
b) To increase the sound level, turn the same knob further clockwise.
2) ASC (Automatic Squelch Control)/SQUELCH :
Suppresses undesirable back-ground noises when there is no communica-
tion. Squelch does not effect neither sound nor transmission power, but allows
a considerable improvement in listening comfort.
a) ASC: Automatic Squelch Control
Worldwide patent, a PRESIDENT exclusivity
Turn the squelch knob (2) counterclockwise to ASC position. «ASC» appears
on the display. No repetitive manual adjustment and a permanent improve-
ment in listening comfort when this function is active. It can be disconnected
by turning the knob clockwise, in this case the manual squelch control
becomes active again. «ASC» disappears.
b) Manual squelch
Turn the squelch knob clockwise to the exact point where all back-ground
noise disappears. This adjustment should be done with precision as, if set to
maximum, (i.e. fully clockwise) only the strongest signals will be received.
3) DISPLAY
Multi-functions LCD display (backlit). It allows visualizing all functions:
31

Publicidad

Tabla de contenido
loading

Tabla de contenido