GLOBBER EXPLORER TRIKE FOLDABLE 4 IN 1 Instrucciones De Montaje página 16

C. Transforming GUIDED TRIKE to TRAINING TRIKE (24-36 months)
When your child is old enough to pedal, remove the parent
handle (push bar) and put the front wheel in locked mode to
allow front wheel pedalling.
1. Press the red button on the bottom rear of the trike frame to
remove the parent handle (push bar).
2. Put the front wheel in locked mode (refer to the section
"HOW TO OPERATE THE FREEWHEEL MODE").
3. Remove the footrest by turning the knob under the footrest
90 degrees and pressing the spring-loaded button on the left
side of the footrest.
4. While facing the front of the trike, make sure the handlebar
lock on the handlebar column is pushed to your left to
enable front wheel steering on the handlebars.
WARNING! Store the parent handle (push bar) in a safe place.
Keep out of the reach of children.
D. Transforming TRAINING TRIKE to BALANCE BIKE (2-5 years)
When your child has mastered his/her coordination and
balance on the training trike, remove the pedals and transform
the rear wheels to allow your child to ride the product as a
balance bike:
1. Press the red buttons under the legs to remove the rear
wheels.
2. Turn the rear wheels over and reinsert them into the same
legs so that the wheels are facing inward (facing each
other) and the parking devices are facing down towards the
ground, and push firmly until the wheels click into place.
3. Remove the pedals by pressing the pedal release buttons on
the front wheel hub. Press the red buttons under the saddle
to insert the pedals into the dedicated holes on the back of
the saddle for storage.
4. While facing the front of the trike, make sure the handlebar
lock on the handlebar column is pushed to your left to
enable front wheel steering on the handlebars.
5. Adjust the saddle height if required. Your child must be able
to place his/her feet comfortably on the ground to stop the
bike.
6. Braking for balance bike: The balance bike can be braked
with the feet. The child can stop the movement by stopping
walking or running. Make sure your child is always able to
stop at the speed produced and wears suitable footwear.
WARNING! Do not use in traffic. Protective equipment must be
worn. Make sure your child always wears safety equipment
(helmet, elbow pads, kneepads and gloves).
Folding the EXPLORER TRIKE (trolley mode)
The trike folds up for easy transport. For infant trike, follow all the
steps below. For guided trike, follow step 1. For training trike, skip
to step 3. For balance bike, skip to step 4.
1. Fold the footrest up, if they are installed on the trike.
2. To fold the harnessed seat (infant trike):
a. Slide the release buttons under the left and right
handlebars to remove the safety bars from the
handlebars.
b. Press the red buttons at the base of the handlebars to
rotate the handlebars up.
c. Slide the security ring up the push bar to unlock the
parent handle from the backrest of the seat.
d. Simultaneously press the large red buttons on both sides of
the seat to fold the backrest.
e. Fold the canopy toward the back.
f. Pinch the 2 red tabs together on the back of the headrest
to fold it backward.
3. Press the red buttons at the base of the handlebars to rotate
the handlebars toward the back.
4. Balance bike only: Press the red buttons under the legs
to remove the rear wheels. Turn the rear wheels over and
reinsert them into same the legs so that the wheels are
facing outward and the parking devices are facing up
towards the ceiling, and push firmly until the wheels click into
place.
ENGLISH
16
5. To fold the legs of the rear wheels, press and hold the red
button on the rear of the trike frame, push the corresponding
leg down and rotate the leg until it points forward. Repeat
the procedure on the other leg.
6. Trolley mode:
a. If the parent handle (push bar) is removed, you can
attach the parent handle to the back of the folded trike
to push/pull in trolley mode.
b. While facing the front of the trike, push the handlebar lock
on the handlebar column to your right to enable front
wheel steering only on the parent handle (push bar).
Unfolding the EXPLORER TRIKE
Follow the steps below to unfold the trike from trolley mode. For
infant trike, follow all the steps below. For guided trike, skip to step
2. For training trike and balance bike, skip to step 3.
1. To unfold the harnessed seat:
a. Press the red buttons at the base of the handlebars to
rotate the handlebars toward the front.
b. Simultaneously press the large red buttons located on
both sides of the seat to unfold the backrest.
c. Unfold the headrest.
d. Press the red buttons at the base of the handlebars to
rotate the handlebars toward the back.
e. Connect the left and right safety bars to the handlebars
and push them until they click into place.
f. Slide the security ring down the parent handle (push bar)
and insert the tab on the ring into the slot in the backrest
to secure the parent handle to the backrest.
g. Adjust the canopy to the desired position.
2. To unfold the legs of the rear wheels, use the red buttons on
the rear of the trike frame. Press and hold the red button to
rotate the corresponding leg until it is fully extended (you
hear a click). Release the button to lock the leg securely in
place. Repeat the procedure on the other leg.
3. Unfold the footrest, if required by the trike mode.
4. Balance bike only: Press the red buttons under the legs
to remove the rear wheels. Turn the rear wheels over and
reinsert them into the same legs so that the wheels are
facing inward (facing each other) and the parking devices
are facing down towards the ground, and push firmly until
the wheels click into place.
Push the handlebar lock into the suitable setting for the
trike mode to enable or disable front wheel steering on the
handlebars and/or parent handle (push bar) (refer to the
section "HOW TO OPERATE THE HANDLEBAR LOCK MECHANISM").
IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
– WARNING! Never leave the child unattended.
– WARNING! Ensure that all the locking devices are engaged
before use.
– WARNING! Do not let the child play with this product in infant
trike mode.
– WARNING! This seat unit is not suitable for children under 6
months.
– WARNING! Always use the restraint system.
– WARNING! Check that the pram body or seat unit or car seat
attachment devices are correctly engaged before use;
– WARNING! This product is not suitable for running or skating;
– Don't attach any carrying accessory, Load attached to the
handle and/or on the back of the backrest and/or on the
sides of the vehicle will affect the stability of the vehicle.
– The parking device shall be engaged when placing and
removing the child.
– WARNING! The child is never to be left in the tricycle
unattended.
– WARNING! The child restraint system that is supplied with the
tricycle is to be used.
– WARNING! If a parcel bag other than one recommended
by the manufacturer is used, then the tricycle may become
unstable.