HTW -GRLC10 Manual De Usuario E Instalacion página 84

Select "YES" and press "OK" to exit the FUNCTION PARAMETER SET.
i INFORMATION
The unit must be turn off before you enter
FUNCTION PARAMETER SET menu. After exiting the
FUNCTION PARAMETER SET, the unit must be power off
and then be power on again in ten seconds.
6.9 FACTORY TEST
FACTORY TEST is only for the factory.
6.10 Network Configuration Guidelines
• The wired controller realizes intelligent control with a built-in module, which receives
control signal from the APP.
• Before connecting the WLAN, please check for it if the router in your environment is active
and make sure that the wired controller is well-connected to the wireless signal.
• During the Wireless distribution process, the LCD icon "
network is being deployed. After the process is completed, the icon "
6.10.1 Wired Controller Setting
The wired controller settings include AP MODE.
Activate the WLAN by interface. Go to"
Press "OK", the following page will appear:
" flashes to indicate that the
" »"WLAN SET"» "AP MODE".
34
"will be constantly on.