Toro Recycler 20357 Manual Del Operador página 14

Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
14). If the bag-on-demand lever is in the recycling
position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear door
Figure 19
1. Rear door
2. Notches (2)
2. Install the grass bag, ensuring that the pins on
the bag rest in the notches on the handle
19).
3. Lower the rear door.
Removing the Grass Bag
To remove the bag, reverse the steps in
Grass Bag (page 13).
13).
(Figure 19).
g208184
3. Grass-bag pin (2)
(Figure
Installing the
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 20).
1. Bag-on-demand lever (in the recycling position)
•
To recycle or side-discharge the grass and
leaf clippings, press the button on the lever and
move the lever rearward until the button on the
lever pops up.
Important:
For proper operation, shut off
the engine, wait for all moving parts to stop,
and then remove any grass clippings and
debris from the bag-on-demand door and the
surrounding opening
move the bag-on-demand lever from 1 position
to another.
1. Clean here
13
Figure 20
(Figure 21) before you
Figure 21
g208185
g206279