Toro Recycler 20357 Manual Del Operador página 19

Servicing the Air Filter
Service Interval: Yearly
1. Press down on the latch tabs on top of the
air-filter cover (Figure
Figure 26
1. Latch tabs
2. Paper air filter
2. Open the cover.
3. Remove the paper air filter and the foam
pre-filter (Figure
4. Inspect the foam pre-filter, and replace it if it is
damaged or excessively dirty.
5. Inspect the paper air filter.
•
If the air filter is damaged or is wet with oil
or fuel, replace it.
•
If the air filter is dirty, replace it or clean it by
tapping it on a hard surface several times or
blow compressed air less than 207 kPa (30
psi) through the side of the filter that faces
the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
6. Remove the dirt from the air-filter body and the
cover using a moist rag.
Important:
Do not wipe dirt into the air duct.
7. Install the foam pre-filter and the paper air filter
into the air filter.
26).
3. Foam pre-filter
26).
8. Install the cover.
Changing the Engine Oil
Service Interval: After the first 5 hours
Yearly
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine oil capacity: 0.5 L (16.9 fl oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
g027782
1. Full
2. Add
4. Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (Figure
18
(Figure
Figure 27
3. Low
28).
17).
27).
g206254