Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING SLIDING FIT BETWEEN CUTTINGHEAD ARM AND TRUNNION
DISCONNECT MACHINE FROM POWER SOURCE.
After a period of time, an adjustment of the sliding fit between
the cuttinghead arm (B) Fig. 27, and the trunnion (C) may be
necessary. To adjust, tighten or loosen the nut (D). Correct
adjustment provides a snug sliding fit between these two
parts. This adjustment should not be so tight that it restricts the
sliding movement of the cuttinghead arm (B) or so loose that it
affects the accuracy of the saw cut.
Overtightening can result in preventing
the cutting head from returning to its
maximum raised position, leaving the blade exposed and
possibly resulting in personal injury.
ADJUSTING THE LOWER BLADE GUARD
DISCONNECT THE MACHINE FROM
THE POWER SOURCE.
This machine incorporates a blade guard (A) Fig. 28 to cover the rear
section of the blade. After an extended period of use, the movable
lower blade guard may not operate smoothly when the cuttinghead
is lowered. This can be corrected by adjusting nut (B) until the lower
blade guard moves freely.
Overtightening the nut could impair guard
movement.
NOTE: This unit has been designed with an
articulating rear guard. Before contacting the
workpiece, the rear guard will rotate upward to
expose more of the blade as the cuttinghead is
lowered.
Do not remove any of the blade guards.
Make sure that all guards are in place and
functioning properly before operating the
saw.
Make sure that the fences are clear of the
guard and blade before operating the saw.
AUTOMATIC ELECTRIC BRAKE
Your saw is equipped with an automatic electric blade brake which stops the saw blade within 5 seconds of trigger
release. This is not adjustable. On occasion, there may be a delay after trigger release to brake engagement. On rare
occasions, the brake may not engage at all and the blade will coast to a stop. If a delay or "skipping" occurs, turn the
saw on and off 4 or 5 times. If the condition persists, have the tool serviced by an authorized Delta Machinery service
center. Always be sure the blade has stopped before removing it from the kerf. The brake is not a substitute for guards
or for ensuring your own safety by giving the saw your complete attention.
B
D
C
16
D
Fig. 27
A
B
Fig. 28
Publicidad
