Genesis GMT35T Manual Del Operario página 4

SPECIFIC SAFETY RULES FOR OSCILLATING MULTI-TOOLS
WARNING:
familiarity with product (gained from repeated use)
replace strict adherence to product safety rules. if you
use this tool unsafely or incorrectly, you can suffer
serious personal injury!
WARNING:
gripping surfaces when performing an operation where
cutting tools may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts
of the tool "live" and shock the operator!
• Always hold the tool firmly. Do not leave the tool
running unless hand held.
• Check your work area for proper clearances
before cutting. this will avoid cutting into your
workbench, the floor, etc.
• Do not cut nails or screws unless you are using
a blade specifically designed for this purpose. inspect
your material before cutting.
IMPORTANT:
Please study them and learn their meaning for critical information to operate the tool safely.
SYMBol DeSCripTion
V
Volts
a
amperes
hz
hertz
w
watts
no load speed
kg
Kilograms
h
hours
.../min
Per minute
Do not let comfort or
hold the tool by insulated
some of the following symbols may be used on your tool and appear throughout the manual.
SYMBol DeSCripTion
revolutions per
rPM
minute
strokes per
sPM
minute
oscillations per
oPM
minute
alternating
current
or a.C.
Direct current
or D.C.
Do not use in
wet conditions
battery cannot
exceed 59° C
Do not put
battery in fire
• Before switching on the tool, be sure the blade
is not contacting the work piece.
• Do not use the tool if the switch does not
turn it on or off. any tool which can not be controlled
by the switch is dangerous and must be repaired.
• Wear cushioned protective gloves to
minimize the vibration. excessive vibration may
cause personal injury.
• Do not wet-sand with this tool. water or
moisture entering the motor housing can cause electric
shock and serious personal injury.
• Always make sure that the tool is switched
off and unplugged before adjusting, adding accessories,
or checking a function on the tool.
WARNING:
warnings, cautions and operating instructions before
using this equipment. failure to follow all instructions
listed below may result in electric shock, fire and/or
serious personal injury.
SYMBOLS
SYMBol
ENGLISH
read and understand all
DeSCripTion
warning symbol. Precautions that involve
your safety
to reduce the risk of injury, read operator's
Manual before using this product
wear safety glasses, ear protection and
respiratory protection
Do not dispose with household waste
Do not touch the running blade
Class ii Double insulated construction
this symbol designates that this product is
listed with u.s. and Canada requirements
by etl testing laboratories, inc.