melitta AromaFresh Pro Manual Del Usuario página 19

If the bean container is ground empty during
preparation, three short signal tones will
sound and the grinding process will be inter-
rupted. A corresponding message will also
appear on the screen.
Fill the bean container with sufficient coffee
beans and confirm with the "OK" button. The
remaining quantity required will be ground
and the preparation continued.
4.4 Setting number of cups
to be brewed
Set the number of cups to be
brewed with the "Cup + " and
"Cup -" buttons.
Always set the number of cups so it corre-
sponds with the filled quantity of water. The
appliance will then use up all of the water in
the water tank. This setting is used to set the
quantity of coffee beans to be ground. The
brewing process will be optimised for the
quantity set.
4.5 Setting grinding fineness
and brewing strength
The grinding fineness basically influences the
flavour of the coffee. If the grinding fineness is
too fine, the coffee will have a bitter taste. If
the grinding fineness is too coarse, the coffee
will taste acidic.
Turn the "grinding fineness regulator" clock-
wise to set a finer grinding fineness. Turn
it anti-clockwise to set a coarser grinding
fineness.
You use the "Strength" buttons
to set the quantity of coffee
beans being ground. The 0 setting deactivates
the grinder allowing you to use ground coffee.
The grinding results and the brewing strength
can vary between different coffee varieties.
You should try out different settings to obtain
the best results. Always start with a medium
setting.
Note: If, despite setting the grinding fineness
and strength, you do not obtain tasty coffee,
you can also set the quantity of coffee beans
to be ground in the menu under Mill Settings.
Note that this setting influences the taste of
the coffee with all strength levels and with any
number of cups set.
5 Preparing coffee
Observe the following instructions during
preparation:
– Start the preparation with the "Start/
Stop" button. The LED flashes green during
preparation.
– You can end preparation at any time by
pressing the "Start/Stop" button again.
– The preparation ends automatically. The
LED lights up green and a signal tone
sounds depending on the setting.
– The drip stop in the filter insert stops cof-
fee dripping when you remove the jug.
– Depending on the setting, the screen is
darkened after a few minutes of inactivity.
Press any button to activate the screen.
– The hotplate also remains switched on
after preparation. The hotplate switches
off automatically only at the end of the set
keep-warm time. The screen shows you the
remaining time until switch off.
– Switch off the hotplate with the "Start/
Stop" button if there is not a jug with
brewed coffee in the appliance.
5.1 Preparing coffee with
coffee beans
1. Fill enough coffee beans into the bean
container.
2. Set the grinding fineness.
3. Fit a suitable filter in the filter insert.
4. Fill the water tank according to the
required number of cups.
5. Place the jug with the lid in the appliance.
6. Set the number of cups to
be brewed.
7. Set the brewing strength.
The strength may not be 0.
8. Start preparation with the "Start/Stop"
button.
Preparing coffee
19