Installing Dust Control Bag; Machine Operation - Nobles UltraShine 1000150 Manual Del Operador Y Piezas

INSTALLING DUST CONTROL BAG

1. Open the dust bag compartment at rear of
machine by the the knob counter-clockwise
(Figure 3).
2. Slide the dust control bag collar over the intake
tube as shown. Prior to operating, always check
that an empty dust bag is installed (Figure 3).
FIG. 3

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
1. Pull and turn the quick-release cord hook upward
and remove the power cord from the machine
(Figure 4).
FIG. 4
UltraShinet Burnisher (09–02)
Home Find... Go To..
2. Plug the power cord into a grounded wall outlet
(Figure 5).
Grounded
3 Hole Outlet
Ground Pin
FIG. 5
FOR SAFETY: Do not operate machine unless
cord is properly grounded. Do not operate
machine with damaged cord or plug. Do not
operate machine with the use of an extension
cord.
3. Lower the handle to a desired operating height by
pulling the handle height adjustment lever.
Release lever to engage handle (Figure 6).
FIG. 6
4. To begin burnishing, depress the safety lock
button, located on top of the handle, and pull the
On/Off levers. Release the safety lock button once
the machine starts (Figure 7).
FIG. 7
OPERATION
11