Installation And Removal Of The Maxi-Cosi Axiss; Important - Maxi-Cosi Axiss Instrucciones De Uso

3 INSTALLATION AND REMOVAL OF
THE MAXI-COSI AXISS
Installation with 3-point belt
(follow red colour marks on product).
OK
OK
CLICK!
OK
Only use the Maxi-Cosi Axiss on a front-facing seat when
the device is used in combination with an adult safety-belt
to be used by means of the following wording: Only suitable
for use in the listed vehicles fitted with lap/3 point/static/with
retractor safety-belts, approved to ECE Regulation No. 16 or
other equivalent standards. (Strike out what does not apply.)
Correct fitting of the car seat belt is essential for the safety
of your child. The seat belt must be attached in the correct
sequence along the red marks on the Maxi-Cosi Axiss. For
further instructions, look on the sticker on the side of the
Maxi-Cosi Axiss. Never fit the seat belt in a way
other than that described.
Remove the headrest of the seat where the Maxi-Cosi Axiss
is to be used in the car if it is in the way. Do not forget to put
the headrest back when the seat is used again.
NO
NO
NO
A. Installation
- CAUTION: Lock fold-down rear seats before installing
the Maxi-Cosi Axiss.
- CAUTION: In some cases, the seat belts are positioned
too far forward. This will make proper installation
impossible. Try a different seat in this case.
The Maxi-Cosi Axiss should preferably be installed on a
rear seat. If this is not possible, it can be installed on the
passenger seat providing this does not contravene local laws
in the country where the car seat is used.
When installing the car seat behind the passenger seat,
position the passenger seat backrest upright and as far
forward as possible so that the child cannot knock it.
IMPORTANT: Always lock the Maxi-Cosi Axiss in a
forwards facing position before driving away.
(Fig. 1 - 4)
Rotating the car seat
The direction of rotation of the Maxi-Cosi Axiss should
always be adjusted to the direction of the nearest car
door.
The button for adjusting the direction of rotation is located on
the underside of the Maxi-Cosi Axiss.
To rotate the seat right.
1. Slide the button towards the back if you want the seat
shell to rotate RIGHT.
To rotate the seat left.
1. Slide the button forwards if you want the seat shell to
rotate LEFT.
2. Open the lever and with one hand hold the lever out
whilst rotating the seat shell with the other to reach the
desired position.
9