Publicidad
Idiomas disponibles
Idiomas disponibles
Important Safety Information • Read all safety information
before operating the equipment. Save theSe InStRuctIonS
Hazard: GeNeraL
May cause property damage or severe injury.
PreveNTION:
• ALWAYS disconnect the heat gun from the power supply when not in use. Store indoors
in a dry place and out of the reach of children.
• Keep your work area well lit and clean.
• Do not overreach, especially when working on ladders. Keep proper footing and balance
at all times. Be certain any ladders being used are sturdy, stable, on a firm surface, or on
firm ground and erected at safe working angles.
• Avoid power lines.
• Keep moveable items secured and steady while scraping.
• Always use protective eyewear when working.
• Stay alert and use common sense when operating any tool.
• When using to thaw frozen pipes, always use the curved deflector (P/N 2366225).
NEvER use to thaw pipes located inside walls or near combustibles.
Some dust, peelings, residue, and vapors caused by paint removal activities
contain chemicals known to the state of California to cause birth defects or
other reproductive harm. an example of a chemical would be lead from lead-
based paints (do not use a heat tool to remove lead-based paint). Your risk
from exposure varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in a ventilated area, and work
with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
Important electrical Information
Use only an extension cord that will accept the plug on the product. Make sure your extension
cord is in good condition. When using an extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. A SJT type cord is required. Cord shall be 14 AWG
minimum for general indoor use.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of
electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not
modify the plug in any way. When servicing, only use identical service parts. Contact WAGNER
for a replacement cordset.
General description
This heat gun is a quality power tool. Like any power tool, it can be dangerous when misused.
Read the following instructions carefully and follow all safety precautions. It is the responsibility
of the owner to use the heat gun properly. Only adults should use a heat gun.
Specifications
Housing: .................Engineered high-impact corrosion and heat-resistant polymers
Wattage: ................1200 Watts on high, 550 Watts on low. Operates on 110-120 vAC
Heat Output: ........Approximately 1100°F on high, approximately 750°F on low
Weight: ...................1.46 pounds
For more details on multiple projects and 'how to' videos
please visit www.wagnerspraytech.com.
4
EN
Save theSe InStRuctIonS
Publicidad
