Ego Power+ SNT2410 Manual De Funcionamiento página 18

NOTE:
Four wire cables can be pulled
slightly towards the handle side to simplify
the assembly, if necessary (Fig. 2c).
INSTALLING THE SNOW-
DISCHARGE CHUTE ASSEMBLY
(Fig. 3)
WARNING:
snow blower without the complete snow-
discharge chute in place.
1. Lift the snow-discharge chute assembly
and align the outer support pole with the
inner support pole (Fig. 3a).
2. Slide the outer support pole down until
the snow-discharge chute is fully seated
on the base.
3. Secure the snow-discharge chute
assembly with one knob and bolt (Fig. 3b).
NOTE:
Four wire cables can be pulled
slightly toward the chute side to simplify
the assembly, if necessary (Fig. 3c).
3b
18
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2410/SNT2410-FC
Never operate the
Knob & Bolt
2c
3a
Snow-
Discharge
Chute
Base
3c
4 Wire Cables
Outer
Support
Pole
Inner
Support
Pole
4 Wire Cables