Ego Power+ SNT2410 Manual De Funcionamiento página 21

2. Loosen the two lower knobs but do not remove them from the side rails during
handle height adjustment.
3. Raise or lower the handle and select the appropriate height determined by one of the
3 hole sets in the side rails (Fig. 5a).
4. Once arriving at the appropriate set of holes, insert the upper bolts and tighten the
upper knobs.
5. Tighten the two lower locking knobs to secure the side rails to the rear handle
(Fig. 5b).
5b
Upper Position
ATTACHING/DETACHING
BATTERY PACK (Fig. 6)
Charge the battery pack(s) before first
use!
NOTE:
The snow blower can be powered
by one or two battery packs. Using two
battery packs gives you a longer run
time and efficient power draw managed
by PEAK POWER™ technology. For best
performance, we recommend use of two
5.0Ah or greater Ah battery packs.
When not in use, 56V battery packs
should be stored in an enclosed area where the temperature will not drop below -4°F
(-20°C). Optimal charging temperature is between 41°F (5°C) and 104°F (40°C).
WARNING:
battery packs to the snow blower or operate the snow blower until the broken or
missing parts are replaced. Failure to do so could result in serious injury.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2410/SNT2410-FC
If any parts are broken or missing, do not attempt to attach the
Middle Position
6a
Lower Position
Battery Compartment
Cover
21