Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
WARNING:
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper bar.
PROBLEM
Snow blower fails to
start.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2410/SNT2410-FC
Always remove the battery pack(s) when servicing or transporting
CAUSE
◾
Battery pack(s) charge is
low.
◾
The auger is frozen by
snow or ice.
◾
The auger is frozen by
snow or ice.
◾
The battery pack is
overheated. The LED
indicator on the battery
pack(s) flashes orange
or shines red. (see the
section "BATTERY
HIGH-TEMPERATURE
PROTECTION" in this
manual.)
◾
Unidentified fault
SOLUTION
◾
Charge the battery
pack(s).
◾
Press the auger-switch
trigger after the power
indicator lights up solid
green. If the power
indicator is off, the snow
blower will not respond
to the pressing of auger-
switch trigger.
◾
Remove the battery
pack(s) first, then use the
supplied chute cleaning
tool to clear the snow
or ice that obstructs the
auger. Restart the snow
blower.
◾
Remove the overheated
battery pack(s) from
the snow blower and
wait until the battery
pack(s) cools down to
approximately 152°F
(67°C). Reinstall the
battery pack(s) and
restart the snow blower.
◾
Contact EGO service
center for repair.
39
Publicidad
