Case C9400DFS Manual De Instrucciones página 10

Assembling the Accessory Kit
NOTE: The wheels are not intended for over-the-road use.
1. Installing the wheels
• Slide the axle through the frame brackets.
• Slide on the hub, wheel and flat washer, then insert the cotter pin
through the wheel axle hole.
• Bend the cotter pin tabs outward to lock the pin in place.
2. Installing the feet bumpers
• Insert an M6 bolt through the rubber bumper and insert an M8 bolt
through the bottom of the bumper bracket. Secure the bolt with an
M8 flange nut.
• Install an M8 bolt though the generator frame and through top of
the bumper bracket. Secure the bolt with an M8 flange nut.
3. Installing the handle assembly
• Insert the handle bracket onto the generator frame and secure with
two M8 bolts and two M8 flange nuts.
• Align the handle assembly holes with the handle bracket holes and
secure with one M8 bolt and one M8 flange nut
10
ASSEMBLY
.