Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING YOUR GENERATOR
Electric Start
1. Make sure all appliances are
disconnected from the generator.
2. Turn engine choke switch to the
"CHOKE" position. (When the engine
is warm or temperature is high, start
engine with the choke switch in the
"RUN" position).
3. Set the key start switch to the
middle "ON" position. Twist it to the
start position and hold in position
until engine starts. Release key and
leave it in the "ON" position when
engine is running.
To prolong the life of starter components, DO NOT hold key in "start"
position for more than 5 seconds, and pause for at least 1 minute
between starting attempts.
Do not connect appliances with defective power cords and/or
plugs.
• Be sure appliances are not connected to generator when
starting up. Starting the generator with an appliance connected
could result in damage to the generator and/or appliances and
personal injury.
• DO NOT turn the starting motor over 5 seconds continuously.
If the engine fails to start, return the toggle switch to the "ON"
position and wait about 10 seconds and then start again.
• DO NOT press the toggle switch to the "START" position when
the engine is running to prevent damage of starting motor.
• Do not overload the generator.
• Do not overload individual panel receptacles. These outlets
are protected against overload with push-to-reset-type circuit
breakers. If amperage rating of any circuit breaker is exceeded,
that breaker opens and the electrical output to that receptacle
is lost.
For electric start, tum and hold key in start switch
to "start" position until generator starts.To
prolong the life of starter components, DO NOT
hold key in "start" position for more than 15
seconds, and pause for at least 1 minute between
starting attempts.
CAUTION
CAUTION
Recoil Starter
ON
OFF
Start
17
9
Publicidad
