Sauder Via Serie Instrucciones De Montaje página 8

Step 4
å
Insert the dowel end of four TWIST-LOCK® FASTENERS (7F) into the 401447
Left End and 401448 Right End as shown in the enlarged diagram.
å
NOTE: If you already pushed TWIST-LOCK® FASTENERS into the holes in the
ENDS (A and B), pull the FASTENERS back out of the holes. Pull at the front
and back edges, slowly working the FASTENERS out of the holes.
å
Push the ENDS (A and B) onto the TWIST-LOCK® FASTENERS in the 401448
Right End and 401447 Left End. Now, tighten eight TWIST-LOCK® FASTENERS.
7F
401448
Credenza Top
401448
Right End
Page 8
U-Shape Assembly
A
B
Finished edge
401446
401447 Desk Top
401447
Left End
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
2
Dowel end
FASTENER
®
www.sauder.com/service