Descargar Imprimir esta página

Sauder Whitaker Point Serie Instrucciones De Montaje página 12

Ocultar thumbs Ver también para Whitaker Point Serie:

Publicidad

Step 6
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (1) to the LEFT END (A). Use six 3/8" PAN HEAD SCREWS (24).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END. Turn a
SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
Page 12
3/8" PAN HEAD SCREW
(6 used in this step)
1
A
1
www.sauder.com/service
1
24
7
429374

Publicidad

loading

Este manual también es adecuado para:

Whitaker point 429374