Sauder Whitaker Point Serie Instrucciones De Montaje página 8

Step 2
å
Fasten the BALLAST (Q) to the SMALL BACK (E). Use
four 1" FLAT HEAD SCREWS (20).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
20
1" FLAT HEAD SCREW
(4 used in this step)
Page 8
Q
E
www.sauder.com/service
Some assembly
(and snacks) required.
The screwhead should
sink down into the larger
hole and be flush with the
surface of the BALLAST.
The hole is closer
to this edge.
The CAM SCREW is
closer to this edge.
429374