Sauder Whitaker Point Serie Instrucciones De Montaje página 15

Step 9
å
Fasten two EXTENSION RAILS (1) to the RIGHT END (B).
Use six 3/8" PAN HEAD SCREWS (24).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes
that lines up with the holes in the END. Turn a SCREW into
these holes.
3/8" PAN HEAD SCREW
(6 used in this step)
429374
24
www.sauder.com/service
1
B
1
Just think. The sooner
you do this, the sooner
you do something else.
Open end
Page 15