Kärcher VC 2 Manual Del Usuario página 19

 Medium suction power – for slightly dirty carpets/
carpeted floors, precious carpets.
 Highest suction power – for hard floors, very dirty
carpets and carpeted floors
 Replace filter bag, at the latest when the filter
change indicator lights up.
See Chapter "Replacing the filter bag".
Illustration
The suction power can be additionally regulated with
the false air slide.
 False air slide open, reduced suction force.
 False air slide closed, normal suction power.
Important notice!The appliance will shutdown auto-
matically, if there is danger of overheating. Turn the ap-
pliance off and pull the power plug. Ensure that the floor
nozzle, the telescopic suction pipe or the suction hose
is not clogged or check if the filter must be changed. Af-
ter the elimination of the disturbance, allow the appli-
ance to cool down for a at least 1 hour; then the appli-
ance is ready for operation again.
Suction using accessories
Using accessories
Illustration
Furniture brush: for cleaning furniture and deli-

cate objects with care, dusting books, air vents in
the car, etc.
 Crevice nozzle: for edges, joints and heaters
Illustration
 Suspend the floor nozzle into the park bracket on
the rear of the unit and push it into the latched po-
sition.
Illustration
 Push the unlocking mechanism of the accessory
compartment.
 Open accessories flap.
 Remove accessories.
 Insert the handle in the desired accessory until the
stop.
Note: The accessories can also be used when the tele-
scopic suction pipe is attached.
Reversible floor nozzle*
* depending on model
Illustration
 Hard surfaces:
 Carpets and carpeted floors:
Illustration
 Hard surfaces:
 Carpets and carpeted floors:
Illustration
 Turn off the appliance and disconnect the mains
plug.
Illustration
 Push the take-up cable button. The cable will pull it-
self automatically into the appliance.
Illustration
 Hang the floor nozzle on the backside of the appli-
ance into the parking holder, and push into the
pause position.
Transport, storage
Illustration
 Lift appliance by the carrying handle and carry it.
Illustration
 Store the appliance in a dry room.
 Hook the floor nozzle into the parking position.
Cleaning and care
ATTENTION
 Before working on the appliance, switch it off and
pull out the plug of the vacuum cleaner!
Before working on the appliance, switch it off and
pull out the plug of the vacuum cleaner!
 Use the device only when all filters and the filter
bag are installed.
Otherwise the motor can get damaged.
 Defective filters and filters that can no longer be
cleaned must be replaced.
Empty/replacing the filter bag
Illustration
 Empty/replace the filter bag if the filter change indi-
cator is on.
Illustration
 Unlock and open the filter cover.
Illustration
 Fold out the filter bracket and remove the filter bag.
Illustration
 Remove filter cap.
 Empty filter bag.
 Close the filter bag.
Illustration
 Push the filter bag into the support until the stop..
 Snap in the cover.
Cleaning the filter bag with water
Note
 Clean the filter bag in case of visible soiling.
 Replace the filter bag in case of damage
ATTENTION
Material damage due to incorrect cleaning of the filter
bag.
 When necessary, clean under running water only.
 Never clean the filter bag in the washing machine.
 Do not wash the parts using detergents or boiling
water.
 Allow the filter bag to dry completely before install-
ing it in the device.
– 9
EN
Finish operation
19