Kärcher VC 2 Manual Del Usuario página 20

 Removing and reinserting the filter bag, see chap-
ter "Empty/replacing the filter bag".
Illustration
 Rinse the filter bag under cold, running water.
 Allow the filter bag to be air-dried by light and heat
sources. Only reinstall the dry filter bag into the ap-
pliance.
Filter for pure blower air.
Note
 Clean the HEPA filter in case of visible soiling.
 Replace the HEPA filter in case of damage
ATTENTION
Material damage due to incorrect cleaning of the HEPA
filter.
 When necessary, clean under running water only,
do not wipe or brush down.
 Never clean the filter in the washing machine and
do not dry it by means of a hair dryer.
 Do not wash the parts using detergents or boiling
water.
 Allow the filter to dry completely before installing it
in the device (at least 24 hours).
Illustration
 Open the cover.
 Unlock the HEPA filter and remove.
Illustration
 Rinse the HEPA filter under cold, running water.
 Shake the filter carefully after cleaning so that any
residual dirt or excess water is removed.
 Allow the filter bag to be air-dried by light and heat
sources. Only reinstall the dry filter bag into the ap-
pliance.
Illustration
 Insert the HEPA filter and snap it into place.
 Insert cover and snap it into place.
Cleaning the floor nozzle
Clean the switchable floor nozzle at reglular intervals!
 Remove the floor nozzle from the telescopic suc-
tion pipe.
 Clean floor nozzle.
Cleaning the accessories
Illustration
 Handle and suction tube can be disconnected in or-
der to clean or if clogged. Push the 2 interlocks and
pull apart.
 Connect handle and suction tube and insert.
20
HEPA filter
Technical specifications
Type
Voltage
Current type
Protective class
Weight (without accessories)
Action radius
Actual dust bag volume
Dimensions
Length
Width
Height
Rated power input
Vacuum min.
HEPA-filter
Sound power level L
Subject to technical modifications!
– 10
EN
V
Hz
kg
m
l
mm
mm
mm
W
kPa
dB(A)
WA
220-240
50/60
II
5.2
7,5
2,8
435
288
250
1100
18
HEPA 12
78