Technical Data; Power Tool Safety Rules - Hilti DAG 451S Manual De Instrucciones

DAG 451S angle grinder
1 Ventilation slots
2 On/off switch
3 Side handle
4 Spindle lockbutton
5 Spindle neck
6 Spindle
7 Disc guard
8 Guard release / lock latch
9 Mounting flange
10 Grinding / disc *
11 Clamping nut
12 Wrench

Technical data:

Rated voltage:
Rated current:
Mains frequency:
Rated speed:
Drive spindle thread:
Grinding disc diameter:
Weight approx. (without accessories):
Insulation class:
Listings/Approvals:

Power Tool Safety Rules

WARNING
Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
Work Area
Keep your work area clean and well lit. Cluttered benches and dark areas
invite accidents.
Do not operate power tools in explosive atmospheres, such as in the
presence of flammable liquids, gases, or dust. Power tools create sparks
which may ignite the dust or fumes.
Keep by-standers, children, and visitors away while operating a power
tool. Distractions can cause you to lose control.
Electrical Safety
Double Insulated tools are equipped with a polarized plug (one blade is
wider than the other.) This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install a polarized outlet. Do not
change the plug in any way. Double Insulation eliminates the need for the
three wire grounded power cord and grounded power supply system. Before
plugging in the tool, be certain the outlet voltage supplied is within the voltage
marked on the nameplate. Do not use "AC only" rated tools with a DC power
supply.
Avoid body contact with grounded surfaces such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock if your
body is grounded. If operating the power tool in damp locations is unavoid-
able, a Ground Fault Circuit Interrupter must be used to supply the power to
your tool. Electrician's rubber gloves and footwear will further enhance your
personal safety.
Don't expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock.
Do not abuse the cord. Never use the cord to carry the tools or pull the
plug from an outlet. Keep cord away from heat, oil, sharp edges or mov-
ing parts. Replace damaged cords immediately. Damaged cords increase
the risk of electric shock.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069465 / 000 / 00
* Accessories
The accessories illustrated or describ-
ed in these instructions are not sup-
plied with the angle grinder.
13 Rubber backing pad *
14 Flexible grinding disc *
15 Round nut *
16 Screw
120 V AC
7.0 A
60 Hz
11000 /min
5 / "–11
8
4 1 / " (115 mm) maximum
2
3.5 lbs (1.6 kg)
Z
II (double insulated)
UL (Underwriters laboratory)
CSA (Canadian Std. Assoc.)