Epson TM-H6000III Manual Del Usuario página 16

English
Inserting Slip Paper
See illustration E.
CAUTION:
Be sure not to insert any magnetic stripe cards into the slip section. Otherwise
the magnetic information will be damaged.
Note:
Be sure that the slips are flat, without curls, folds, or wrinkles.
Troubleshooting
ERROR LED is on or flashing.
❏
The print head temperature may be extremely high. Wait until the print head
cools and the printer resumes printing automatically.
❏
Make sure that the roll paper and unit cover are properly closed.
❏
Turn off the printer, and check for a paper jam. Please see the description
below.
❏
The autocutter may be jammed. See the description below.
❏
Turn off the power, wait several seconds, and then turn it on again. If the
error remains, contact your qualified service person.
Paper/card jam occurs.
❏
If a paper jam occurs in the receipt section, open the roll paper cover to
remove the jammed paper.
❏
If a paper jam occurs in the slip section, open the unit cover; then push the
levers backward to open the unit. Remove the jammed paper.
❏
If a card is jammed in the card image scanner section, open the roll paper
cover; then push the blue tab down in the direction indicated by the arrow in
illustration F and pull it toward you to open the card feed path. Remove the
jammed card.
Note:
After removing the jammed card, be sure to close the card feed path. If the path is not
closed, the red shutter will close the card entrance to prevent the card from being inserted.
The autocutter is jammed or the roll paper cover will not open.
1. Turn off the printer, and open the unit cover.
2. Then turn the knob (A) until you see a pin (B) in the opening. See
illustration G.
6 TM-H6000III with Image Scanner (Photo-ID Model)