Epson TM-H6000III Manual Del Usuario página 18

English
CAUTION:
Do not insert checks with staples in them. This may cause paper jams, MICR
reading errors, and damage to the MICR head.
Be sure the checks are flat, without curls, folds, or wrinkles.
Be sure not to insert any magnetic stripe cards into the slip section. Otherwise
the magnetic information will be damaged.
See illustration I.
1. Wait until the SLIP LED flashes. Then insert the check face up with the right
side of the check against the right side of the paper guide as far as it will go.
Be sure that the MICR characters are on the right. See the arrow in the
illustration for the proper location of the MICR characters.
2. The printer will detect the check and start drawing it in. When the printer
starts drawing it in, let go of the check immediately. When the printer ejects
the check and the SLIP LED starts flashing again, remove the check by pulling
it straight out; do not pull it at an angle.
Cleaning the MICR Mechanism
Foreign matter in the mechanism can cause MICR reading errors. Clean the MICR
head with a moistened cleaning sheet approximately every 12 months.
Use the following or an equivalent commercially available cleaning sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD"
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load roll paper in the printer, turn off the power, then open the roll paper
cover and turn the power back on while holding down the RELEASE button.
2. Press the RELEASE button 7 times, then
close the roll paper cover. The printer
prints the following message on receipt
paper, and the SLIP LED flashes.
3. Insert the cleaning sheet like a standard
check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is
inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
4. When the sheet is ejected, press the RELEASE button, and remove the sheet
from the printer.
Notes on using the MICR reader
Do not install the printer near any magnetic fields. Be especially careful where you
install your display device, and be sure to check the recognition rate of the MICR
reader with the display device in place.
Make sure that the printer is not subjected to any impact or vibration when it is
performing a MICR reading.
8 TM-H6000III with Image Scanner (Photo-ID Model)